Hi,
i have an at91sam9263-ek board.
i flash mcu using samba for demo programs without any problem.
Which boot code should i load and also where should i load it in(NAND, NOR etc )
for getting-started-project-at91sam9263-ek demo program?
There are also soamae other things i really dont understand.
For example what the data flash is?
is it a serial flash or internal rom?
i will be really very greteful if somebody helps me flashing and running
getting-started-project-at91sam9263-ek sample project at least. :)
Another question about the group:
is the group really used actively?
i have some doubts about the group and also the at91 family
are not very popular. There are too little answers for questions lately.
Regards
MCU flashing problem getting-started-project-at91sam9263-ek sample program
Started by ●March 22, 2010
Reply by ●March 22, 20102010-03-22
I do not know you really need boot code for the blinky program. You can write
the code to the flash memory(the NAND flash) and the romboot program will load
the code into the SRAM. The code will run in the SRAM.
The dataflash is the memory when you plug a dataflash card into the dataflash card slot.
________________________________
From: mehmetrizaoz
To: A...
Sent: Mon, March 22, 2010 7:02:37 AM
Subject: [AT91SAM] MCU flashing problem getting-started-project-at91sam9263-ek sample program
Hi,
i have an at91sam9263- ek board.
i flash mcu using samba for demo programs without any problem.
Which boot code should i load and also where should i load it in(NAND, NOR etc ) for getting-started- project-at91sam9 263-ek demo program?
There are also soamae other things i really dont understand.
For example what the data flash is?
is it a serial flash or internal rom?
i will be really very greteful if somebody helps me flashing and running getting-started- project-at91sam9 263-ek sample project at least. :)
Another question about the group:
is the group really used actively?
i have some doubts about the group and also the at91 family
are not very popular. There are too little answers for questions lately.
Regards
The dataflash is the memory when you plug a dataflash card into the dataflash card slot.
________________________________
From: mehmetrizaoz
To: A...
Sent: Mon, March 22, 2010 7:02:37 AM
Subject: [AT91SAM] MCU flashing problem getting-started-project-at91sam9263-ek sample program
Hi,
i have an at91sam9263- ek board.
i flash mcu using samba for demo programs without any problem.
Which boot code should i load and also where should i load it in(NAND, NOR etc ) for getting-started- project-at91sam9 263-ek demo program?
There are also soamae other things i really dont understand.
For example what the data flash is?
is it a serial flash or internal rom?
i will be really very greteful if somebody helps me flashing and running getting-started- project-at91sam9 263-ek sample project at least. :)
Another question about the group:
is the group really used actively?
i have some doubts about the group and also the at91 family
are not very popular. There are too little answers for questions lately.
Regards
