PIC24HJ64GP206, ICD2 -> ICD0083: Debug: Unable to enter debug mode.

Hi

I hoping some one might be able to point me in the right direction.

I am using a PIC24HJ64GP206 with an ICD2 connected to PGD2 and PGC2.
When I tell the ICD2 to connect to the target it does so without
error, identifies the chip etc.... see below;

Connecting to MPLAB ICD 2
...Connected
Setting Vdd source to target
Target Device PIC24HJ64GP206 found, revision = Rev 0x3002
...Reading ICD Product ID
Running ICD Self Test
...Passed
MPLAB ICD 2 Ready

However, if I build my code and tell it to program the chip i get
ICD0083: Debug:  Unable to enter debug mode.  Please double click this
message for more information    See below.

Programming Target...
...Validating configuration fields
...Erasing Part
...Programming Program Memory (0x0 - 0x4FF)
Verifying...
...Program Memory
...Verify Succeeded
...Loading DebugExecutive
...Programming DebugExecutive
...Debug Executive
...Programming Debug Vector
...Debug Vector
...Programming Configuration Bits
.. Config Memory
Verifying configuration memory...
Connecting to debug executive
ICD0083: Debug:  Unable to enter debug mode.  Please double click this
message for more information.
MPLAB ICD 2 Ready

Does anyone have any ideas as to what I can/should check ?

I have used the C18 compiler with the PIC18F series devices but this
is my 1st application using c30 on a PIC24.

All helpful comments,things to check etc.... welcome.

Thanks in advance

Anbeyon

On 25 May 2007 07:27:36 -0700, the renowned Anbeyon
<anbeyon@btinternet.com> wrote:

>Hi
>
>I hoping some one might be able to point me in the right direction.

http://forum.microchip.com/tm.aspx?m=141274


Best regards, 
Spehro Pefhany
-- 
"it's the network..."                          "The Journey is the reward"
speff@interlog.com             Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog  Info for designers:  http://www.speff.com

On 25 May, 17:06, Spehro Pefhany <speffS...@interlogDOTyou.knowwhat>
wrote:
> On 25 May 2007 07:27:36 -0700, the renowned Anbeyon
>
> <anbe...@btinternet.com> wrote:
> >Hi
>
> >I hoping some one might be able to point me in the right direction.
>
> http://forum.microchip.com/tm.aspx?m=141274
>
> Best regards,
> Spehro Pefhany
> --
> "it's the network..."                          "The Journey is the reward"
> s...@interlog.com             Info for manufacturers:http://www.trexon.com
> Embedded software/hardware/analog  Info for designers:  http://www.speff.com

Thanks - It was cable length related - all seems OK now :0)