Does anyone have any example software developed for the AT91SAM7L-STK
board? The ATMEL supplied software is only a simple LCD scroll.
Thanks,
TomC
Reply by Ulf Samuelsson●October 9, 20102010-10-09
tomcee skrev:
> Does anyone have any example software developed for the AT91SAM7L-STK
> board? The ATMEL supplied software is only a simple LCD scroll.
>
> Thanks,
> TomC
Most AT91SAM7 applications are useable (with small modification)
on the SAM7L
Best Regards
Ulf Samuelsson
Reply by tomcee●October 11, 20102010-10-11
On Oct 9, 5:56=A0am, Ulf Samuelsson <u...@notvalid.atmel.com> wrote:
> tomcee skrev:
>
> > Does anyone have any example software developed for the AT91SAM7L-STK
> > board? =A0The ATMEL supplied software is only a simple LCD scroll.
>
> > Thanks,
> > TomC
>
> Most AT91SAM7 applications are useable (with small modification)
> on the SAM7L
>
> Best Regards
> Ulf Samuelsson
That could be very helpful information. I would appreciate any
recommended sources of these mentioned applications.
Thank you,
TomC
Reply by Boudewijn Dijkstra●October 11, 20102010-10-11
Op Fri, 08 Oct 2010 20:28:03 +0200 schreef tomcee <tomcees_pc@yahoo.com>:
> Does anyone have any example software developed for the AT91SAM7L-STK
> board? The ATMEL supplied software is only a simple LCD scroll.
The IAR Embedded Workbench for ARM comes with the following example
applications:
getting-started-project
basic-dataflash-project
basic-internalflash-project
basic-lowpower-stk-project
basic-pwm-project
basic-rtc-project
basic-serialflash-project
basic-slcd-stk-project
basic-twi-eeprom-project
--
Gemaakt met Opera's revolutionaire e-mailprogramma:
http://www.opera.com/mail/
(remove the obvious prefix to reply by mail)
Signal Processing Engineer Seeking a DSP Engineer to tackle complex technical challenges. Requires expertise in DSP algorithms, EW, anti-jam, and datalink vulnerability. Qualifications: Bachelor's degree, Secret Clearance, and proficiency in waveform modulation, LPD waveforms, signal detection, MATLAB, algorithm development, RF, data links, and EW systems. The position is on-site in Huntsville, AL and can support candidates at 3+ or 10+ years of experience.