Piclist
A discussion group for the PICMicro microcontroller. Also called the Microchip PIC, this list is dedicated to the use and abuse of this fine, simple, microcontroller. Close to topic posts are welcome, ie. general electronics.
Post a new Thread
cresswell - Dec 13 2007
--------------Boundary-00=_0EROQL80000000000000
Content-Type: multipart/alternative;
boundary="------------Boundary-00=_0EROLVC0000000000000"
--------------Boundary-00=_0EROL... 
james pruett - Dec 13 2007
I need to buy one. Any leads appreciated.
-jim
... 
saurabhgupta_ece2005 - Dec 13 2007
hello everyone.
i am new to PIC microcontroller,so i need help. However i have a lot
of experience on avr microcontroller but now i want to work on PIC.
i need to know about... 
harrabylad - Dec 13 2007
Are you going back to bank 0 after the osccal is set ?
to unsubscribe, go to http://www.yahoogroups.com and follow the instructions
... 
NEWBIE [2 Articles]
sseyon - Dec 13 2007
Hello there i am just entering world of microcontrollers. I am here
because my hardware design needs to store a string of data which is in
CMOS levels and also time stamp the dat... 
Eirik Karlsen - Dec 13 2007
There are several free and open source bootloaders out there.
Just Google for "pic bootloader"
james pruett wrote:
> Eg, what do I buy? I dont need Incircuit emulation and I ... 
james pruett - Dec 13 2007
Eg, what do I buy? I dont need Incircuit emulation and I only use the one
chip. Cheap is my middle name.
Thanks for any replys.
I have been using modtronix PICs for 3 years,... 
Felipe Cerqueira skylazart - Dec 13 2007
I have been working in a project to decode modem signals: DTMF tones, Called
ID and modulate signals in low rate QAM (until 14400).
I do have few knowledge in eletronics, so i de... 
that dude - Dec 13 2007
I was trying to create a simple Audio processor using a Micro chip
16F877A and a SI3000 chip. I am having trouble figuring out what the
best way to interface the two chips togeth... 
wibbley - Dec 13 2007
Hi all, I have been pulling my hair out trying to enable a WPU in a
12F629. The pin detects an input if i put 5V on it, but shows as
clear when not. If a WPU was set, it should... 
previous |
6 |
7 |
8 |
9 |
10 |
11 |
12 |
13 |
14 |
15 |
16 |
17 |
18 |
19 |
20 |
21 |
22 |
23 |
24 |
25 |
next