Anyone tried the cc2500emk example code files meant for the development kit on ez430-rf2500? I did some modification on the code but it still doesn't seem to work.

Does anyone know if there is something wrong with this part of the code?

void TI_CC_PowerupResetCCxxxx(void)
{
TI_CC_CSn_PxOUT |= TI_CC_CSn_PIN;
TI_CC_Wait(30);
TI_CC_CSn_PxOUT &= ~TI_CC_CSn_PIN;
TI_CC_Wait(30);
TI_CC_CSn_PxOUT |= TI_CC_CSn_PIN;
TI_CC_Wait(45);

TI_CC_CSn_PxOUT &= ~TI_CC_CSn_PIN; // /CS enable
while (TI_CC_SPI_USCIB0_PxIN&TI_CC_SPI_USCIB0_SOMI);// Wait for CCxxxx ready
UCB0TXBUF = TI_CCxxx0_SRES; // Send strobe
// Strobe addr is now being TX'ed
IFG2 &= ~UCB0RXIFG; // Clear flag
while (!(IFG2&UCB0RXIFG)); // Wait for end of addr TX
while (TI_CC_SPI_USCIB0_PxIN&TI_CC_SPI_USCIB0_SOMI);
TI_CC_CSn_PxOUT |= TI_CC_CSn_PIN; // /CS disable

------------------------------------



(You need to be a member of msp430 -- send a blank email to msp430-subscribe@yahoogroups.com )