Sign in
Search lpc2000
Subscribe to lpc2000
lpc2000 by Keywords
2106 | ADC | ARM7 | Atmel | Bootloader | CAN | CrossStudio | CrossWorks | DDS | ECos | Ethernet | ETM | FIFO | FLASH | FPGA | GCC | GDB | GNU | GNUARM | GPIO | I2C | IAP | IAR | JTAG | Kickstart | LCD | Linux | LPC | LPC-E2294 | LPC2000 | LPC2100 | LPC2104 | Lpc2106 | Lpc210x | LPC2114 | LPC2119 | LPC2124 | LPC2129 | Lpc2138 | LPC213x | LPC21xx | LPC2210 | LPC2212 | LPC2214 | LPC2292 | LPC2294 | LPC2xxx | LPC3128 | MCB2100 | Olimex | Philips | PWM | Rowley | RTC | RTOS | SPI | SSP | UART | UART0 | UART1 | ULINK | USB | Watchdog | Wiggler
Ads
Discussion Groups
Discussion Groups | LPC2000 | Needing to reset device (LPC2468) after programming with ULINK2
Discussion group dedicated to the Philips LPC2000 family of ARM MCUs
Needing to reset device (LPC2468) after programming with ULINK2 - kermitvi2 - Oct 6 1:07:58 2008
Hello,
I am having an issue with Keil RealView MDK, ULINK2 and an LPC2468
based IAR dev board.
The problem I have is after I load the program onto the device, it
doesn't automatically start up. I have to reset the device.
This was not the case when I was using the KEIL tools with a KEIL
MCB2300 board. After programming the device would automatically reset
with no problem and start running.
------------------------------------
(You need to be a member of lpc2000 -- send a blank email to lpc2000-subscribe@yahoogroups.com )
I am having an issue with Keil RealView MDK, ULINK2 and an LPC2468
based IAR dev board.
The problem I have is after I load the program onto the device, it
doesn't automatically start up. I have to reset the device.
This was not the case when I was using the KEIL tools with a KEIL
MCB2300 board. After programming the device would automatically reset
with no problem and start running.
------------------------------------
(You need to be a member of lpc2000 -- send a blank email to lpc2000-subscribe@yahoogroups.com )