We were working on our senior project. We do have the code. We are
using the HC11 software. After connecting everything, when we complied
our code nd pressed the reset button, we saw buffalo on the screen.
After that, typed load t nd used the terminal option nd did the ASCII
download on the board. After it was done successfully, we were suppose
to write g 2000, but instead we seeing rom-0200. When we write g 2000
after that message, nothing happens.
we not sure, what we doin wrong..Any help would b appreciated...
Thankxx...
krish.



(You need to be a member of hc11 -- send a blank email to hc11-subscribe@yahoogroups.com )