Sign in
Search fpga-cpu
Subscribe to fpga-cpu
fpga-cpu by Keywords
Altera | CISCifying | IDE | ISA | Java | JHDL | JTAG | LBU | MicroBlaze | PAR | PCI | RISC | SoC | Spartan | Transputers | Verilog | VHDL | Virtex | VLIW | WebPack | Xilinx | Xsoc | YARD-1A
Ads
Discussion Groups
See Also
Discussion Groups | FPGA-CPU | FPGA Development Board Needed
This list is for discussion of the design and implementation of field-programmable gate array based processors and integrated systems. It is also for discussion and community support of the XSOC Project (see http://www.fpgacpu.org/xsoc).
FPGA Development Board Needed - Author Unknown - Nov 14 13:16:00 2001
|
I need to buy a FPGA development board with the following: Xilinx or other with 600,000 to 1 Million Gate Count 4 High Speed A/D (50-60 Msps) 4 High Speed D/A (50-60 Msps) 2 A/D 1 D/A Thanks-Ali |
|
|
controlSUITE™ software. Comprehensive. Intuitive. Optimized.
Real-world software for real-time control. Details Here!
(You need to be a member of fpga-cpu -- send a blank email to fpga-cpu-subscribe@yahoogroups.com )
Re: FPGA Development Board Needed - Ed Corter - Nov 14 15:33:00 2001
|
I'll check with my last place of employment. The board has an ARM cpu, DP ram, Sram( non volitile ), Sram (volitile), flash, 4 Virtex1000E's and a compact pci interface, level translator for seril comm, and lots of 2x20 IDC headers to all of the fpga's there is a LVPECL clock circuit that has equalized trace lengths and DLL feed back routed for board de-skew. 1 AtoD & 1 DtoA ( bot are intended for Rf applications ) they were running at 93.33mHz on our design the DAC did 4x interpolate convert. It has baseband mode and bandpass mode.. etc.. If they out grew the platform ( design size speaking ) there will be board available. The board doesn't need the 400 PCI backplace to be used. I Just wired 5, 3.3, 1.8 V's to the PCI pin Pads and put standoff's on the board to keep it off of the desk for better cooling an survivability. Ecorter __________________________________________________ |
(You need to be a member of fpga-cpu -- send a blank email to fpga-cpu-subscribe@yahoogroups.com )
Re: FPGA Development Board Needed - Ed Corter - Nov 14 16:58:00 2001
|
There are boards and they would be sold as is. I am sure theat they would run the standard SW test of all peripherals and at the least establish that the JTAG chain of the 4 devices is intact and all devices are configuralbe. If you are serious about a board with near 1 Million Gates for developement. also there is a surplus of Virtex 1000E and 2000E devices still in original packgaing. If interested email: I would guess the board to cost somwhere around 3-8 thousand bucks. There may also be another board that has only 1 1000E on it along with a motorolla PowerPC CPU. perhaps cheaper ???? __________________________________________________ |
(You need to be a member of fpga-cpu -- send a blank email to fpga-cpu-subscribe@yahoogroups.com )