AT90S2313 | AT90S8515 | ATMega | ATmega128 | ECL | FETS | IAR | Keyboard | LCD | STK50 | TMOS | UART

I am having trouble getting C to work on AVR studio

I downloaded the latest winavr beeing 20090313
WinAVR-20090313-install.exe all 22 meg of it

I installed -avr-studio-aStudio4b401.exe (42 Meg) version 4.11
that I had on my hard drive
I was using the notes I found via google
http://www.elec.uow.edu.au/avr/guides/Getting-started-C-programming-Atmel-AV
R.pdf
a ten page article
but when I go to make a project it will only do it in assembly code

all I get in fig 7.1 of the instrutions is ATMEL AVR assembler
sorry I most go to work now, if your goes or there is a "set up" to do now I
would be interested to get them

>From Eric

------------------------------------



(You need to be a member of avrclub -- send a blank email to avrclub-subscribe@yahoogroups.com )

On my rush to get to work, I thought " "what a twit" maybe there are
instrutions I did not read"
I am now looking for them

>From Eric
----- Original Message -----
From: Eric
To:
Sent: Thursday, June 25, 2009 7:29 AM
Subject: [AVR club] I am having trouble getting C to work on AVR studio
I am having trouble getting C to work on AVR studio

I downloaded the latest winavr beeing 20090313
WinAVR-20090313-install.exe all 22 meg of it

I installed -avr-studio-aStudio4b401.exe (42 Meg) version 4.11
that I had on my hard drive
I was using the notes I found via google
http://www.elec.uow.edu.au/avr/guides/Getting-started-C-programming-Atmel-AV
R.pdf
a ten page article
but when I go to make a project it will only do it in assembly code

all I get in fig 7.1 of the instrutions is ATMEL AVR assembler
sorry I most go to work now, if your goes or there is a "set up" to do now I
would be interested to get them

>From Eric

------------------------------------



(You need to be a member of avrclub -- send a blank email to avrclub-subscribe@yahoogroups.com )