Sign in
Search AT91SAM
Subscribe to AT91SAM
Ads
Discussion Groups
Discussion Groups | AT91SAM ARM | Re: how to set the address for program entry
For users of the Atmel AT91SAM7 and AT91SAM9 ARM CPU chips. Atmel has taken a new direction by combining on chip flash and ram with the ARM CPU on a single die. This provides low cost devices for small systems using the ARM CPU. This group is to exchange information to help users get started and learn how to use the devices.
Re: how to set the address for program entry - 42Bastian - Mar 26 3:30:24 2008
l...@yahoo.ca schrieb:
> Hi, everybody
> I am trying to migrate from IAR EWARM 4.11 to 5.11.
> Working on a AT91SAM7S256, how could I link the Cstartup code to the beginning of code flash, instead of jumping to __iar_program_start, which is located in somewhere in the middle of ROM.
The reset-vector will jump there (just check your flashed image at 0!).
--
42Bastian
Note: SPAM-only account, direct mail to bs42@...
------------------------------------
(You need to be a member of AT91SAM -- send a blank email to AT91SAM-subscribe@yahoogroups.com )
> Hi, everybody
> I am trying to migrate from IAR EWARM 4.11 to 5.11.
> Working on a AT91SAM7S256, how could I link the Cstartup code to the beginning of code flash, instead of jumping to __iar_program_start, which is located in somewhere in the middle of ROM.
The reset-vector will jump there (just check your flashed image at 0!).
--
42Bastian
Note: SPAM-only account, direct mail to bs42@...
------------------------------------
(You need to be a member of AT91SAM -- send a blank email to AT91SAM-subscribe@yahoogroups.com )